Caighdeáin Cothabhála Slabhra Tarchuir

Tá an Slabhra Tarchuir Is struchtúr tarchurtha an-chriticiúil é i dtrealamh meicniúil, a chuireann isteach ar fheidhmíocht oibre agus ar shaol seirbhíse an trealaimh. Dá bhrí sin, tá sé an-riachtanach an slabhra a chothabháil ag gnáth-amanna.

1. Tá an sprocket should be installed on the shaft without skew or swing. The end faces of the two sprockets in the same assembly should be in the same plane. When the center distance of the sprocket is less than 0.5 meters, the allowable deviation is 1 mm; when the center distance of the sprocket is more than 0.5 meters, the allowable deviation is 2 mm. However, it is not allowed to rub the side of the sprocket tooth. If the two-wheel knitting is too large, it will easily cause chain disconnection and accelerated wear. When replacing the sprocket, check and adjust the offset.
2. Tá an tightness of the chain should be appropriate. Too tight increases power consumption and bearings are easy to wear; too loose chain is easy to jump and fall off. The tightness of the chain is: lifted or pressed down from the middle of the chain, the center distance between the two sprockets is about 2%-3%.
3. Tá an chain is too long or stretched after use, and it is difficult to adjust. You can remove the chain-link depending on the situation, but it must be an even number. The chain link should pass through the back of the chain , the lock piece should be inserted outside, and the opening of the lock piece should face the opposite direction of rotation.
4. Tar éis an sprocket a chaitheamh go mór, ba cheart an sprocket nua agus an slabhra nua a athsholáthar ag an am céanna chun meshing maith a chinntiú. Ní féidir slabhra nua nó sproicéad nua a athsholáthar ina n-aonar. Seachas sin, beidh sé ina chúis le meshing bocht agus luasghéaróidh sé caitheamh an slabhra nua nó an sprocket nua. Nuair a bhíonn dromchla fiacail an sprocket ag caitheamh go pointe áirithe, ba cheart é a iompú agus a úsáid in am (ag tagairt don sprocket a úsáidtear le dromchla inchoigeartaithe). Chun an t-am úsáide a leathnú.
5. Tá an old chain cannot be mixed with part of the new chain, otherwise, it is easy to have an impact on the chain and break the chain.